- Sensor electronics easily removed from tee.
- Impeller/bearing/shaft easily replaced in field without changing calibration.
- Two wire sensor. Power and signal transmit on single pair of wires up to the distance of 600 m.
- Digital signal easily interfaced with transmitters, monitors or PLCs.
- Installation can also be done directly in the ground (IR model)
Water
from 1.1 up to 340 l/min
from 0 up to 100 °C
from 0 up to 27 bar
Water & waste water industry, Chemical industry
General information
The series 250 flow sensor features a six bladed impeller design with aproprietary non-magnetic sensing mechanism. The unique impeller is less prone to be fouled by water borne debris. The forward curved shape coupled with the absence of magnetic drag provides improved operation and repeatability even at lower flow rates. This is especially true where the impeller is exposed to metallic or rust particles found in steel or iron pipes.
As the liquid flow turns the impeller, a low impedance square wave signal is transmitted with a frequency proportional to the flow rate. The signal can travel up to 600 m between the flow sensor and the receiving unit without the need for amplification.
All sensors except irrigation versions are supplied with a 6 m 2-conductor 20 AWG shielded U.L. type PTLC 105°C cable and meet CE standards for noise immunity and susceptibility.
Technical data
Mounting in pipe sizes DN | 6 – 32 / 0,5 – 1,5“ |
Flow range in m/s (standard) | 0,1 – 4,5 |
Flow range in m/s (low flow) | - |
Accuracy (full scale / Qmax.) | ±1 % v. M. |
Accuracy (of reading) | - |
Repeatability (full scale / Qmax.) | ±0,7 % |
Measuring principle
Impeller meters

The series feature a six-bladed impeller design with a proprietary, non-magnetic sensing mechanism. The impeller shape coupled with the absence of magnetic drag provides accuracy and repeatability throughout the flow range of the sensors. As the liquid flow turns the impeller, a low impedance square wave signal is transmitted with a frequency proportional to the flow rate.
Accessories
- Scaled pulse output: 2 analog outputs or 2 frequency outputs available
- 1 relay output
- Communication via EIA-485 ModBus®...
- Control panel mounted
- Pump control based on flow and pressure
- Pump control based on level and pressure
- Water feature...