- Large, bi-directional flow measuring range
- Reduced installation time and cost
- No moving parts to maintain or replace
Water, Lightly aggressive fluids, Lubricant oil, Water-based fluids, Liquid food
from -20 up to 60 °C
Water & waste water industry, HVAC, Chemical industry, Pharmaceutical industry, Food & beverage industry, General industry, Oil industry
General information
The TFX-5000 transit time meter measures volumetric flow and heating/cooling energy rates in clean liquids as well as those with small amounts of suspended solids or aeration, such as surface water or sewage.
TFX-5000 ultrasonic flow and energy meters clamp onto the outside of pipes and do not contact the internal liquid.
Technical data
| Liquid types | Most clean liquids or liquids containing small amounts of suspended solids or gas bubbles |
| Repeatability | 0.2% of reading |
| Power Options | 24V DC/AC or Mains AC |
| Enclosure | NEMA Type 4X, IP67 |
| Ambient Temperature Range | -4…140° F (-20…60° C) |
| Storage Temperature Range | -40…176° F (-40…80° C) |
Downloads
- Overview/Flyer_DE.pdf
- Overview/Flyer_EN.pdf
- Overview/Flyer_PL.pdf
- Overview/Flyer_Applications_EN.pdf
- Overview/Flyer_TFX-5000_DE.pdf
- Overview/Flyer_TFX-5000_EN.pdf
- Datasheet_DE.pdf
- Datasheet_EN.pdf
- Datasheet_PL.pdf
- User manual_EN.pdf
- User manual_DE.pdf
- User manual_ModbusRTU_DE.pdf
- User manual_ModbusRTU_EN.pdf
- User manual_BacnetMSTP_EN.pdf
- User manual_BACnet/IP Ethernet_EN.pdf
- User manual_EtherNet-IP_EN.pdf
- Installation manual_RTD_DE.pdf
- Installation manual_RTD_EN.pdf
- Installation manual_EasyRail-DTTJK_DE.pdf
- Installation manual_EasyRail-DTTJK_EN.pdf
- Wiring diagramm_EN.pdf
- Installation manual_SoloCUE_DE.pdf
- Installation manual_SoloCUE_EN.pdf
- Installation manual_Firmware Update_DE.pdf
- Installation manual_Firmware Update_EN.pdf
Measuring principle
Heat meters
The heat meters use the highly precise ultrasonic transit time measuring principle, for which two ultrasonic sensors are externally mounted on the pipeline and connected to the electronic. The ultrasonic sensors work alternately as transmitter and receiver, and mutually send ultrasonic signals. During these transmissions, the respective signal transit times of the to-and-from signals (t1, t2) are measured.
The electronic measures the difference of the transit time of the ultrasonic signals going with and against the flow direction t1 and t2. These signals are either decelerated or accelerated by the medium flow. The difference produced in both signal transit times is proportional to the flow rate and is used together with the pipeline geometry for a precise flow calculation
Accessories
- Fast leak detection
- No special infrastructure required
- Data retrieval available anytime